Used Brandt OPTIMAT KD 78/ 2C Automatic Edge Bander with used Ligmatech ZHR 01/R/045 Return Conveyor. Edgebander equipped with a PC-16 Program Control with a 7.4" color LCD screen, 8 MB IDE Flash Disc 100 MHZ 486 DX4 Hard Drive, 8 MB RAM and internal modem for remote diagnostic link; with automatic height adjustment for top pressure beam with all work stations with digital height indicator; signal light at infeed for panel spacing; automatic magazine for strip and coil feeding with a large coil table (800mm diameter) for up to 3mm PVC; Quickmelt granulate glue application system; quick-change glue tank; reversible rotation of glue application roller; infrared radiant quartz heating unit between glue roller and pressure zone for optimum gluing strength; first pressure roller driven and three idle pressure rollers; with a two motor end trimming unit for straight and up to 15 degrees chamfer with pneumatic indexing via program control; top and bottom fine trimming station with digital "Quickset" system with tilt from 0 to 25 degrees with pneumatic indexing via program control; second top and bottom fine trimming station with digital "Quickset" system with tilt from 0 to 25 degrees with indexing via program control; two motor contour trimming station for corner rounding/trimming; sound and safety enclosure with centralized dust extraction outlet; with top and bottom scraping station with pneumatic indexing via program control; with an electronic frequency changer for all trimming motors with electronic brakes; with electrical controls wired for AC 3/60/230 volt operation; having an edgeband thickness capacity of 0.016-1/2"; edge band height capacity of 1/2" to 2-3/8"; minimum panel length of 6-3/8" and a minimum width capacity of 2-3/8"; with panel thickness capacities of 5/16" min. and 2-3/16" max.; with a feed motor delivering a feed rate of 46 F.P.M. Year 2001 Note: Not available until May 2016, Can be seen in operation.