1-used BIESSE LATO 38 EDGEBANDER. 8 mm capacity edgebanding thickness, min. panel width: 85 mm or 50 mm w/250 mm panel length, min. panel length: 140 mm, max. panel thickness: 45 mm, auto strip and coil feed magazine with 3 mm PVC guillotine, Teflon coated hot melt glue pot, dual digital thermostats, 1 in. diameter glue applicator roller, pressure section w/ (1) large diameter non-stick coated drive roller and (2) pneumatic pressure controlled idle rollers, horizontal adjustment w/ digital indicator Workstations: front and rear end trims (.5 HP motors), motors travel on 45 degree slides and tilt 0-12 on a horizontal plane. Top and bottom rough trim (.73 HP motors), motors tilt 0 -30 degrees Top and bottom fine/bevel/profile trims (.73 HP motors), motors tilt 0-30 degrees, cutters for 10 degree bevel and 3 mm PVC radius round, digital readouts for setup (t and b w/ quick change motors for tool change) Top and bottom scrapers for 3 mm thick PVC banding, pneumatic pressure control for scraping knives, digital readout for horizontal adjustments, top and bottom hot air blowers, top and bottom buffing (.5 HP motors) units tilt 0-30 degrees. Feed chain "anti-slip" 80 mm wide rubber pads. Feed Speed: 33 FPM w/ 2 HP drive.